Whether a stroller works in everyday life is often decided not when you push it, but at the trunk. You can check this before you buy – with three measurements.
How to measure your trunk
- Length: from the start of the loading lip to the back of the rear seat, measured along the floor.
- Width: between the wheel wells – that's the narrowest point, not the width at the top.
- Height: from the floor to the cargo cover or to the lower edge of the tailgate.
Subtract 2–3 cm from each measurement. That gives you room to load and unload without having to force it.
Reading the folded dimensions correctly
Manufacturers usually state the folded dimensions with wheels, some without. At Buggino, the data sheet shows the folded dimensions the supplier provides – and, where the supplier says so, whether they apply with or without wheels. If a detail is missing, we say so openly in the “To be honest” section.
How to compare properly
Put your three trunk measurements next to the folded dimensions in the stroller's data sheet: the length, width and height of the folded stroller should each be at least 2–3 cm smaller than the space in your trunk. Not sure? Send the three measurements and your car model to info@buggino.com or call us at +49 89 20003903 – we'll work it out with you.
Tip: take the wheels off
On many 2-in-1 strollers, the wheels can be removed. Depending on the model, this saves a few centimeters and often makes the difference with small cars – in that case, measure the frame without the wheels and place the wheels next to it.